SYSTEM SYNCHRONIZATION
A brand new system must be charged before first use. Make sure to charge both the transmitter and receiver.
Synchronization is normally not required for a new system.
When you order an additional collar or replace your old remote transmitter, the system has to be re-synchronized.
To do so, please follow these steps:
1.Make sure that both the remote transmitter and receiver are fully charge.
2.Turn on the remote transmitter. Use Collar Selection Button to choose between collar 1 or collar 2 - there is no difference between which one you choose.
3.Turn off the receiver collar. When it's off, press and hold the Power Button for about 5 seconds until Red LED Light starts flashing. Flashing LED Light indicates that the collar is ready to be synchronized with remote.
4.While Red LED is flashing, use remote transmitter to send any stimulation signal to the collar. The collar should make a beeping sound and LED flashing will stop - the collar is now synchronized with the remote and the system is ready to be used.
Notes:
1.The system cannot be synchronized while it's charging.
2.The receiver collar will stay in synchronization mode for about 20 seconds. If no signal is sent from remote during this time, the collar will automatically quit the synchronization mode.
3.A brand new product must be charged before first use.
4.There is a movement sensor inside the collar which can make a rattling noise when you shake it.
Package Included:
1 х Remote Transmitter
1 х Receiver Collar
1 х AdjustaЫe Collar Strap
1 х USB Charge СаЫе
1 x Charger
2 х Set of Metal Contact Points
1 х User Manual